Products

3. ACCESSORIES FOR CONTROL UNITS AND SENSORS

1. Control units 2. Gas detection transmitters 3. Accessories for control units and sensors 4. Industrial communication 5. Domestic detectors 6. Accessories for domestic material 7. Other equipment

SENSORS

LS3 SUPPORT FOR S/3 SENSORS

Reference

03665

Accessory for mounting the S3 sensors to the roof or other horizontal surface that allows the correct mounting position to be maintained with the sensor that is vertically pointed downwards. Suitable whenever installation on a wall or vertical surface is not possible.

User manual support ls3

<span>LS3</span> SUPPORT FOR <span>S/3</span> SENSORS

TULIPA ANTI-SALPICADURAS PARA SENSORES S/3 Y S/2

Reference

Dimensions

04056

10 cm alto, Ø 10 cm

The splash guard is an accessory that protects the sensor.

User manual splash guard

TULIPA ANTI-SALPICADURAS PARA SENSORES <span>S/3</span> Y <span>S/2</span>

TRANSMITTER PROTECTOR S/3 AND S/2

Reference

Dimensions

04687

248 x 150 x 105 mm

Stainless steel wall-mounting accessory to protect the S/3 and S/2 transmitters from possible mechanical impacts and splashes.

User manual s/3 and s/2 protector

TRANSMITTER PROTECTOR <span>S/3</span> AND <span>S/2</span>

GAS MANIFOLD CONE

Reference

Dimensions

03645

Ø 30 cm

The gas manifold cone is an accessory that attaches to the gas detection transmitter to improve the capture of gases lighter than air such as methane, hydrogen, etc. in installations where sensors are placed above the points where leak or gas emission could take place.

User manual gas collector cone

MS-WD-RS485 MODULE RS-485

Reference

04163

Optional communications module for FIDEGAS^® toxic S/3, S/2 and S/10 gas detection transmitters with serial communication that enables RS-485 connectivity.

User manual ms-wd-rs485

Cover S-3 with active carbon filter

Reference

01314

The FIDEGAS^® activate carbon filters protect the sensor against external contaminants, without causing any interference in the detection of the target gas. The filter is contained in a special cover to be placed on the sensor support.

User manual mask s3 with activated carbon filter

Cover <span>S-3</span> with active carbon filter

MÓDULO DE RELÉS MS3-RE V3

Reference

03932

Accessory module of the FIDEGAS^® remote sensors with which remote relay outputs suitable for connection to other systems are provided: two configurable alarm outputs such as NA or NC and with interlocking or non-interlocking and a failure output.
Factory configurable alarm levels or later by software.

User manual ms3-re v3

M-CAL CALIBRATION MODULE

Reference

04015

Accessory module for gas transmitters in the Ref. S/3 or S/2 (T1, T2, Series, IR) and two-wire Ref. TG-2H range that allows field calibration using buttons or a magnet.

User manual m-cal

MIR V3 DISPLAY MODULE

Reference

Buzzer

Consult

03809

03829

Módulo display opcional para sensores remotos S/3 FIDEGAS^® que permite visualizar en el propio sensor remoto la concentración medida en tres dígitos.

User manual display module mir v3